Baby Back Ribs on a Kamado: Beyond the 3-2-1 Method
Roel WestraHow do you get tender baby back ribs with a proper crust and a little bite? In this cook on the Monolith Avantgarde, Roel follows the colour and tenderness of the meat. He smokes the ribs until the outside is ready, wraps them to finish cooking, then puts them back over the charcoal to firm up the surface.
The takeaway: look for a mahogany-red exterior before wrapping, check that the meat is tender before unwrapping, and give the ribs a short final spell on the grill. The clock helps you plan; the condition of the ribs tells you when to move on.
Baby back ribs with PitmasterX Pork Seasoning
Roel chooses meaty baby back ribs for this demonstration. His aim is juicy pork with a well-developed exterior, rather than a rack that simply collapses as soon as you pick it up.
He seasons both sides with PitmasterX Pork Seasoning, paying attention to the edges and any loose flaps of meat that can otherwise miss the rub. There is no binder or marinade. The seasoning sits on the ribs while the surface becomes moist and the rub adheres.

The seasoning used in this cook
PitmasterX Pork Seasoning is the only rub Roel applies to these ribs. It goes directly onto the pork before the smoking stage.
Shop Pork SeasoningScoring the membrane instead of removing it
For this particular setup, Roel leaves the membrane on the bone side and scores it with a knife. He wants the underside to take on colour and texture during the exposed cooking stage, while the bones and membrane face the heat below.

The Monolith Avantgarde setup: a small fire and a high grate
Roel starts with the charcoal area roughly half filled and lights a small section in the centre. With the lower vent open, he lets the charcoal establish for about five to ten minutes. He then reduces the airflow and brings the kamado up to around 120°C / 250°F gradually.
In the video, that warm-up takes roughly half an hour. His reason for taking it slowly is control: he wants a steady smoking setup before the ribs go on.
The important detail is inside the grill. Roel removes the drip trays and heat deflectors and places the cooking grates at their highest position. The ribs sit bone side down above the charcoal, with plenty of distance from the fire.

He uses an oak-barrel wood chunk for the stronger smoke flavour he wants here. The raised grate, controlled fire and direct exposure are all part of the setup. Simply taking the deflector out of a much hotter grill would produce a different cook.
Roel describes this as an Argentinian-style approach inside a ceramic barbecue: heat reaches the underside directly, while the warmed ceramic surrounds the ribs. He also likes the flavour created as fat drips towards the charcoal.
Three stages, guided by the ribs
1. Smoke until the colour is there
At the first check, about an hour and a half into the cook, Roel looks at both sides. He wants colour underneath and a mahogany-red exterior on the meat side, with the seasoning set on the surface.
That appearance is his signal to move on. The first stage has built the outside he wants; the next stage is about getting the meat tender.

2. Wrap with a little butter and sweetness
Roel lays a few slices of butter on aluminium foil and adds a small drizzle of maple syrup or honey. The ribs go on with the bone side towards the butter, and he closes the foil around them.
The quantities are modest. In his recap, he specifically warns against adding so much liquid that the ribs end up boiling in the parcel. He returns the wrapped ribs to the grill to finish cooking.

His initial estimate for this stage is about two hours. Later, he reports a little over two and a half hours before the ribs are ready to unwrap. That change is exactly why he does not want a fixed timetable to decide the result.
In this cook, Roel reaches a core temperature of 96°C / 205°F, then checks tenderness as well. He describes the resistance as similar to soft, creamy butter. The meat is delicate enough that he handles the rack carefully when taking it out of the foil.
He explains that the wrapped stage can continue at the original cooking temperature, or at around 140°C / 285°F to move it along faster. Either way, tenderness determines when the wrapped stage is finished.
3. Unwrap and firm up the exterior
The ribs go back onto the grill, unwrapped, for about ten minutes. This final stage firms up the surface after the time spent in foil.
Sauce is optional. Roel says you can add it at this point or leave the ribs dry. The final texture matters more to him than a thick, sweet coating.

The result: close to fall-off-the-bone, with a little bite
Roel’s verdict is that the ribs are juicy and tender, with a crust he likes and meat that leaves a clean bone while keeping a little bite. He describes them as very close to fall-off-the-bone, rather than completely falling apart.
That distinction is the goal of this cook. The smoking stage develops the outside, the wrapped stage softens the meat, and the short return to the grill finishes the surface.
| Stage | What he looks for | Timing in this cook |
|---|---|---|
| Smoking | Colour underneath and a mahogany-red meat side. | First check after about 1½ hours. |
| Wrapped cooking | Tender meat with very little resistance. | About 2 hours estimated; a little over 2½ hours reported later. |
| Unwrapped finish | A firmer exterior. | About 10 minutes. |
The timings describe this demonstration. Rack thickness, fuel, heat and the grill setup can change how long another cook takes.
Questions about this rib method
Do I need to follow 3-2-1?
Roel follows the condition of the ribs instead. His stages still include smoking, wrapping and finishing, but he changes stages when the colour or tenderness is right rather than after a prescribed number of hours.
Why is the grate so high?
There is no heat deflector between the fire and the ribs in this demonstration. Raising the grate creates more distance from the charcoal while keeping that direct exposure.
Do these ribs need barbecue sauce?
No. Roel presents sauce as an option for the final stage. The Pork Seasoning, smoke and exterior developed during the cook are central to his dry finish.
For another example of managing bark and tenderness on a kamado, see our foil-boat beef ribs cook.
Watch the complete baby back ribs cook
See the scored membrane, the Monolith Avantgarde setup and Roel’s final verdict in the original video.
- 0:00 — Why Roel moves beyond a fixed 3-2-1 schedule
- 0:33 — Charcoal and a gradual kamado warm-up
- 1:53 — Choosing baby back ribs
- 3:16 — Scoring the membrane
- 3:32 — Pork Seasoning without a binder
- 4:21 — A high grate without heat deflectors
- 6:14 — The first colour check
- 7:04 — Wrapping with butter and a little sweetness
- 7:36 — Why the timings vary
- 8:39 — Unwrapping and checking tenderness
- 9:26 — A short final grill finish
- 9:43 — The final bite and recap
Equipment and seasoning used
- Monolith Avantgarde: the ceramic barbecue used in this video, with the grates raised and the heat deflectors removed for the exposed stage. Monolith supports this PitmasterX video. Explore the Monolith Avantgarde.
- PitmasterX Pork Seasoning: applied to both sides of the baby back ribs without a binder. Shop Pork Seasoning.
Pork Seasoning is our own PitmasterX product. This cook also uses charcoal, an oak-barrel wood chunk, aluminium foil, butter and a small drizzle of maple syrup or honey.
