The finished pork rib roast with browned, scored fat and exposed rib bones

Smoked Pork Rib Roast with a Crispy Fat Cap

Roel Westra

A big pork rib roast deserves a careful cook. Roel prepares this one with a simple injection brine, a crosshatched fat cap and layers of Pork and Texas Seasoning, then roasts it on the Monolith Avantgarde. The result is juicy sliced pork with a crisp, salty edge of rendered fat.

THE SEASONINGS IN THE VIDEO

Pork first, Texas on top

Roel uses PitmasterX Pork Seasoning as his first layer, followed by Texas Seasoning for the outside of the roast. Use the same pairing for this cook.

Recipe at a glance

30 minutesEstimated preparation
3½–4 hoursCooking time in the video
20 minutesEstimated rest
140°C / 284°FInitial barbecue temperature
65°C / 149°FTarget core temperature
4 h 20–4 h 50Estimated total time

The cook time comes from Roel’s large roast. Preparation and rest are estimates for this written recipe. The video does not state the roast’s weight.

How many people does a pork rib roast serve?

Allow 200 g of cooked meat per person. Using an estimated 20% loss for bone and rendered fat, each kilogram of raw bone-in roast provides about four portions.

Portions = raw weight in kilograms × 4. For example, a 4 kg roast would provide about 16 portions. That is a planning example, not the measured weight of the roast in the video; the actual yield depends on its bones and fat.

Ingredients

The roast and seasoning

Injection brine — one batch

  • 1 litre (4¼ US cups) cold water
  • 50 g (1.8 oz) salt
  • 20 g (0.7 oz) sugar, optional

How to cook the pork rib roast

  1. Prepare the pork rib roast

    Ask your butcher for a bone-in pork rib roast with the skin removed, the rib bones cleaned and the fat cap left on. Check that the roast fits inside your barbecue before lighting it. Roel uses a large 12-rib section; you can use a smaller roast and follow its core temperature rather than copying the cooking time.

  2. Mix and inject the brine

    Stir the salt and optional sugar into the cold water until dissolved. Using a meat injector, distribute the brine across the thick meat at several points. This is the brine batch size, not an instruction to inject the entire litre into every roast. The amount the meat takes up depends on its size. Discard leftover brine that has been in contact with the raw pork.

    Roel injecting brine into the pork rib roast
    Roel injects the brine at several points across the pork roast.
  3. Score and season the fat cap

    Score the fat diagonally in two directions to make a crosshatch pattern, cutting through the fat without cutting deeply into the meat. Work flaky sea salt into the cuts, then coat the roast with Pork Seasoning followed by Texas Seasoning. Keep in mind that the brine and the rubs already contain salt.

    Flaky sea salt added to the crosshatched fat cap
    A crosshatch pattern divides the fat cap into small sections for the finish.
  4. Set up the Monolith Avantgarde

    Light the charcoal and set up the barbecue for indirect roasting. Stabilise it at around 140°C / 284°F. Place the roast on the cooking grate with the meat side down and the fat cap facing up. Close the lid.

    Roel placing the large pork rib roast on the Monolith Avantgarde
    The large rib roast goes onto the Monolith Avantgarde with its fat cap facing up.
  5. Roast and check the centre

    Cook until the centre reaches 65°C / 149°F, checking the thickest part of the meat with the ChefsTemp Finaltouch X10 and keeping its tip clear of bone. Roel’s very large roast takes about 3½–4 hours. Use the temperature reading to decide when your own roast is ready; a smaller roast can finish sooner.

  6. Finish the fat cap

    Towards the end, Roel increases the heat slightly to give the outside more colour and crispness. Watch the fat closely during this finish and continue checking the core so the roast does not cook beyond your intended finish.

  7. Rest, carve and serve

    Transfer the roast to a board and rest for about 20 minutes before carving. This resting time is an estimate for the written recipe; the video shows a rest without giving its exact length. Slice between the bones or remove the meat from the rack and carve it. Serve each portion with some of the seasoned, rendered fat cap.

    Roel carving the rested pork rib roast
    After resting, Roel carves into the finished pork rib roast.

Details that matter

This is crisp fat, not skin crackling

The butcher removes the skin before the cook. The crosshatched layer is the fat cap. Keeping that distinction clear helps you ask for the right cut and understand the finish shown in the video.

Use the brine consistently

Keep the water-to-salt ratio the same if you make a smaller batch. The optional sugar is part of Roel’s mixture; it is not required for this recipe.

Give a large roast enough room

Roel’s rack only just fits his barbecue. A smaller rack is a practical option at home. Keep the method, but let the core reading guide the finish instead of assuming it needs the full time used for his large roast.

Eight months behind one roast

This is the first large cut Roel cooks from pigs he raised himself. His butcher prepares the rack, leaving the substantial fat cap that Roel wanted for barbecue. He loves the finished meat, while being candid that raising the pigs took far more work and money than buying a good roast. You can make this recipe with a butcher-prepared pork rib roast.

Equipment used

MAIN SPONSOR

Monolith Avantgarde

The ceramic barbecue used for this roast. Set it up for indirect cooking, then adjust the heat for the final fat-cap finish.

Explore the Monolith Avantgarde

ChefsTemp Finaltouch X10

Check the thickest part of the pork with the instant-read thermometer, positioning the tip in the meat rather than against a rib bone.

Current partner offer: use code PITMASTERX for 25% off in the ChefsTemp shop.

Shop the Finaltouch X10
  • Meat injector and mixing bowl for the brine.
  • Sharp knife for scoring and carving.
  • Large board and heat-resistant barbecue gloves.

Monolith is the main sponsor. ChefsTemp is the thermometer partner. The equipment links above are sponsor links to the official websites.

Watch the pork rib roast cook

Original video: I Spent 8 MONTHS Raising a Pig for This? · Published 30 May 2026.

Cooked by Roel Westra

Roel is the cook behind PitmasterX. This recipe is based on his filmed cook and transcript, with original frames from the video. Preparation, rest and portion estimates are identified above.

For another approach to pork with a generous fat layer, see our full belly ribs comparison.

Tillbaka till blogg