Close-up of a sliced baby back rib showing the meat and browned exterior after cooking on a gas grill

Smoking Ribs on a Gas Grill: Smoke, Bark and No Wrap

Roel Westra

A gas grill can produce smoky ribs with a proper bark. In this cook, Roel uses the Napoleon Prestige PRO 665, apple wood in smoker boxes and two water trays beneath the meat. The interesting part is how those elements work together—and why he finishes these baby backs without wrapping them.

Can you smoke ribs on a gas grill?

Yes. Roel's setup separates three jobs: the outside burners supply heat, the smoker boxes supply smoke, and water trays shield the ribs below the upper rack. He builds the bark first, checks tenderness and core temperature, then adds a short final glaze.

The three-part gas grill smoking setup

Roel's starting point is an earlier successful brisket cook on gas. For the rib experiment, he wants smoke flavour and a developed exterior while keeping the meat away from the strongest direct heat.

He removes the outside cooking grids and sear plates to make room for smoker boxes over the outside burners. The two centre grids go back in, with water trays on top. The ribs sit higher, on the upper rack, above those trays.

Two water trays on the centre grates of the Napoleon Prestige PRO 665
Two water trays sit beneath the upper rack, with the smoker boxes positioned toward the sides.
What each part does in Roel's setup
Part Role in the cook
Outside burners Heat the smoker boxes and provide the heat for the cooking chamber.
Apple wood chips Supply the smoke flavour that the gas flame alone does not provide.
Water trays Sit between the meat and the heat below; Roel uses them as a heat shield and to moderate the cooking environment.
Upper rack Keeps the ribs above the trays and away from the direct burner positions.

Use smoker accessories designed for your grill and leave its ventilation openings clear. This approach uses the grill's existing airflow; it does not depend on sealing the barbecue shut.

Why Roel values the airflow

Roel sees a gas grill's ventilated construction as an advantage for developing the surface of the meat. In his explanation, hot moving air helps build the crust. The smoker boxes add the flavour he would otherwise miss from cooking with gas alone.

The water trays are the other part of that arrangement. They sit below the rack rather than enclosing the ribs. The surface remains exposed throughout the bark-building stage.

Start the smoke, then manage the heat

Roel fills the smoker boxes with apple wood chips without packing them tightly. In this filmed setup, he first uses a higher burner setting to get the wood smoking, then turns the outside burners down for the cook.

Smoke production needs attention along the way. When the first wood charge has burned down, he adds more chips for another smoking session. The useful distinction is between controlling the heat and keeping a supply of smoking wood: one burner setting does not remove the need to watch both.

Roel replenishing a smoker box with apple wood chips during the rib cook
Apple wood chips are replenished during the cook to produce another smoke session.

Season the ribs evenly

These are baby back ribs. Roel removes the membrane from the bone side, applies Pork Seasoning generously and lets the rack stand for about 10 minutes before cooking. Because it is windy, he holds the seasoning closer to the meat to keep the coating even.

He then puts the rack above the water trays and closes the lid. At that height, the lid thermometer gives him an indication of the conditions near the ribs. It remains a chamber reading; the meat gets its own temperature check later.

Judge the bark before reaching for sauce

After about an hour, the ribs have a pronounced brown exterior. Roel points to the colour and developing crust as evidence that the setup is doing what he wants. He decides the ribs have enough smoke, but continues the hot-air cooking for at least another half hour to develop the surface further.

Baby back ribs developing a browned bark on the upper rack above the water trays
The bark develops before the final layer of barbecue sauce is added.

This is an important separation: smoke flavour, bark and tenderness do not have to reach their finishing points at the same moment. Once he is happy with the smoke, the cook continues for texture.

Finish for tenderness, then set the glaze

Near the end, Roel uses the ChefsTemp Finaltouch X10 to check the meat. His stated finishing range in this cook is 92–96°C / 198–205°F, alongside ribs that are turning soft. The probe reading informs the decision; the colour alone does not tell him the inside is ready.

Only then does the sauce become the focus. He mixes a ketchup-based glaze with cola, honey whiskey, Worcestershire sauce, maple syrup and Pork Seasoning, and warms it beside the ribs. The point here is the timing: build the surface first, then brush on the sauce near the finish.

Barbecue sauce warming beside the ribs on the Napoleon gas grill
The sauce warms on the grill before the ribs receive their finishing glaze.

The glazed rack gets about five more minutes for the sauce to become sticky. Roel then gives it a 10-minute rest before slicing.

Why these ribs stay unwrapped

There is no foil-wrapping stage in this cook. Roel credits the water-bath setup with allowing him to keep going without enclosing the ribs. The finished meat is juicy, and the exterior has the crust and sticky finish he was looking for.

That is the result of this batch and setup, rather than a promise that a water tray makes every rack impossible to dry out. Rib size, heat exposure and the point at which you stop cooking still matter.

Roel slicing the rested baby back ribs on a cutting board
After the rest, Roel slices the rack to inspect the meat and taste the result.

The taste-test verdict

Roel finds the ribs soft and tender, with meat that releases cleanly from the bone. He can taste the smoke, pork, seasoning and sauce. For him, it is a convincing demonstration that gas can produce the barbecue result he wants.

The video does not include a matching charcoal-cooked rack alongside this one. Its strongest evidence is the finished gas-grill cook itself: developed bark, a little visible smoke ring and an enthusiastic tasting verdict.

Equipment and partner links

Main sponsor

Napoleon Prestige PRO 665

The outside burners heat the smoker boxes while the ribs cook on the upper rack above water trays.

View the Prestige PRO 665 at Napoleon
Core-temperature checks

ChefsTemp Finaltouch X10

Roel uses this instant-read thermometer to check the ribs as they approach the finishing stage. The rotating probe helps you reach the right angle without relying on surface colour alone.

Use code PITMASTERX for 25% off at ChefsTemp.

Shop the Finaltouch X10

Smoking accessories: Roel uses smoker boxes, apple wood chips and water trays. For a purpose-made box that fits this grill series, see the Napoleon Stainless Steel Smoker Box.

Questions about smoking ribs on gas

Where do the ribs sit?

On the upper rack above the centre water trays. The smoker boxes and active burners are toward the outside.

Does the water bath replace the smoker boxes?

No. They have different roles. The water trays sit between the heat and the ribs; the wood chips supply the smoke.

When does Roel add barbecue sauce?

Near the end, after the bark has developed and the ribs are turning soft. He gives the glaze about five minutes to become sticky.

Do these ribs need a wrapping stage?

Roel completes this cook without wrapping. He judges the result from the meat, temperature check and final texture.

Watch the full video

Watch on YouTube

  1. 00:00 — The gas-grill challenge
  2. 01:14 — Smoker boxes and apple wood
  3. 01:32 — The water-bath setup
  4. 03:16 — Replenishing the smoke
  5. 03:37 — Checking the bark
  6. 04:12 — Core temperature and finishing
  7. 05:05 — Resting, slicing and the verdict
Roel Westra · PitmasterX

Based on Roel's original gas-grill rib cook. The photographs are original frames from the video.

Explore another use for the same barbecue: our spider steak test over a charcoal insert. For a longer smoke, read the pulled pork guide to bark and wrapping.

Vissza a blogba